Dynon Avionics SkyView Classic - 1 Introduction

SkyView System Installation Guide - Revision AA 1-1
1. Introduction
It is the installer’s responsibility to conform to industry standards as applicable.
This guide provides information about the physical (mechanical), electrical, and pneumatic
installation and configuration of the following SkyView major system components:
 Advanced Flight Systems (AFS) ADVANCED Control Module (included as part of an
ADVANCED Quick Panel System)*
 Angle-of-Attack (AOA) / Pitot Probe (details specific to the SkyView system)
 Encoder Serial-to-Gray Code Converter
 Capacitance to Voltage Converter
 Engine and environmental sensors purchased from Dynon Avionics (and selected
other sensors)
 SkyView Video Input Adapter
 SkyView Wi-Fi Adapter
 SV32 Autopilot servo (all variations, generic installation details)
 SV42 Autopilot servo (all variations, generic installation details)
 SV52 Autopilot servo (all variations, generic installation details)
 SV-AP-PANEL Expert Autopilot Control Panel / Trim Controller**
 SV-ADAHRS-200 ADAHRS Module
 SV-ADAHRS-201 ADAHRS Module
 SV-ADSB-470 ADS-B Receiver Module*
 SV-ARINC-429 ARINC 429 Interface Module*
 SV-BAT-320 Backup Battery
 SV-COM-C25 and SV-COM-X83 COM Radios
 SV-D600 SkyView SE Display
 SV-D700 SkyView Classic Display
 SV-D900 SkyView SE Display
 SV-D1000 SkyView Classic Display
 SV-D1000T SkyView Classic Display
 SV-HDX800 SkyView HDX Display
 SV-HDX1100 SkyView HDX Display
 SV-EMS-220 Engine Monitoring Module
 SV-EMS-221 Engine Monitoring Module
 SV-GPS-250 GPS Receiver Module
 SV-GPS-2020 GPS Receiver Module
 SV-KNOB-PANEL Knob Control Panel
 SV-MAG-236 Remote Magnetometer
 SV-XPNDR-261 Transponder
 SV-XPNDR-262 Transponder