Dynon Avionics SkyView Classic - Electrical Connections

SV-COM-X83 Installation and Configuration
17-8 SkyView System Installation Guide - Revision AA
Electrical Connections
Harness Construction
Because the SV-COM-X83 (SV-COM-PANEL connected to SV-COM-T8) can be mounted in a
variety of locations, the harness length requirements will vary from airplane to airplane. Thus,
Dynon Avionics does not supply pre-manufactured harnesses for the SV-COM-X83. Instead,
your SV-COM-X83 includes connectors and pins to generate a wide variety of harness
configurations. Refer to the sections below for detailed wiring information.
Additional harness construction and wiring information can be found in Appendix C: Wiring and
Electrical Connections.
The SV-COM-PANEL has two (electrically identical) D9M connectors for connection to SkyView
Network and one D15M connector for connection with the SV-COM-425 and an optional
Frequency Flip/Flop pushbutton input.
The SV-COM-T8 has one D25M connector for connection to the SV-COM-PANEL, power, audio,
and Push to Talk (PTT). A single TNC Female connector attaches to the antenna.
SV-COM-PANEL – D15M Pinout
Pin
Function
Notes
1
POWER IN
10-30V DC @ 5A
2
GROUND IN
Connect to Ground Bus
3
Ground Out
Optional - For Grounding Pin 7 (Flip/Flop
Switch). Switch may also be grounded
locally.
4
Panel RX / 425 TX
Connect to SV-COM-T8 Pin 6
5
Panel TX / 425 RX
Connect to SV-COM-T8 Pin 5
6
Enable
Connect to SV-COM-T8 Pin 13
7
External Flip/Flop
(optional)
Push Button Normally Open to Ground
(Pin 3 or local ground)
8
No Connection
(Pin not used)
9
No Connection
(Pin not used)
10
No Connection
(Pin not used)
11
No Connection
(Pin not used)
12
No Connection
(Pin not used)
13
No Connection
(Pin not used)
14
No Connection
(Pin not used)
15
No Connection
(Pin not used)
Table 94 – SV-COM-PANEL D15M Pinout