Basic SkyView Display Operation
SkyView System Installation Guide - Revision AA 3-9
To set the function of a SkyView HDX knob:
1. Push the knob (pushbutton) to enter the knob’s Function Menu.
2. Choose the joystick function by rotating the knob clockwise or counter-clockwise.
3. Confirm the highlighted function by pushing the knob (pushbutton)
OR
Wait approximately 7 seconds; the Function Menu will close and the highlighted
function will be selected.
If the Map Page is onscreen, the joystick or knob closest to the Moving Map is labeled (RNG) and
is used to adjust the map’s range. It cannot be assigned a different function.
If the Joystick / Knob Function menu does not display all of the Bugs that you wish
to select from, some of the Bugs are disabled. To enable the desired Bugs, go to the
PFD menu and select BUGS. In the BUGS menu, enable the desired bugs. Then the
desired Bugs will be selectable in Joystick / Knob menu.
How to Enter the Setup Menus
There are two setup menus: the Setup Menu and the In Flight Setup Menu. Simultaneously
pressing and holding buttons 7 and 8 will open one of these menus. If airspeed is zero, the
Setup Menu opens. If airspeed is greater than zero, the In Flight Setup Menu opens.
You may also access the Setup Menu from the In Flight Setup Menu by using the ENTER FULL
SCREEN SETUP MENU… option.
How to Adjust Time Zone Offset
First, configure the Top Bar to display time in SETUP MENU > LOCAL DISPLAY SETUP > TOP BAR
SETUP > TIME: ZULU | LOCAL.
Then, adjust your preferred offset from the time currently displayed on the Top Bar – SETUP
MENU > SYSTEM SETUP > TIME.
How to Configure Units of Measure
Displayed units can be configured for altitude, distance and speed, temperature, barometer,
pressure, and volume. Displayed units are configured on the Measurement Units Page (SETUP
MENU > SYSTEM SETUP > MEASUREMENT UNITS).
In Flight Setup Menu
This menu contains links that may be useful during flight:
ADAHRS SOURCE SELECTION…
FLIGHT ANGLE PITCH ADJUST…
COMPASS CALIBRATION….
AOA CALIBRATION…
AUTOPILOT SETUP…
ENTER FULL SCREEN SETUP MENU…
To Next Page
Loading...
