SV-GPS-250/2020 GPS Receiver Installation and Configuration
SkyView System Installation Guide - Revision AA 8-5
Figure 92 – SV-GPS-250/2020 Mounting Dimensions
Mounting hardware is not included. The SV-GPS-250/2020 is designed to install with #8
fasteners with 100 degree countersunk heads. The use of nut plates is recommended for
convenience, but other hardware can be used if space allows. Specific hardware selection is
determined by the installer.
We recommend the use of weather sealant around the fastener heads to keep moisture from
entering the aircraft through the mounting holes. The module itself is sealed and includes a
rubber gasket that seals the inner wire hole. It also allows the module to be mounted on
slightly curved surfaces. For extra protection, you may use weather sealant around the outside
of the SV-GPS-250/2020 where it meets the skin of the aircraft.
To Next Page
Loading...
