Appendix A: Maintenance and Troubleshooting
21-4 SkyView System Installation Guide - Revision AA
SkyView Display Scenario 1: When the documentation furnished with the repaired
display indicates that is being returned to you with the exact same
settings/configuration as it was sent to Dynon Avionics with
1. In this case, the display contains EXACTLY the same configuration as it did when you
sent it in. If your system was working properly before the display failed and was sent in
for repair:
a. Reinstall the display, reconnecting all harnesses and connections as originally
installed.
2. Power up the entire SkyView System (all displays, modules, servos, etc.)
3. If this is the only display installed:
a. Reconfigure SkyView Network under SETUP MENU > SYSTEM SETUP > SKYVIEW
NETWORK SETUP > CONFIGURE…
b. Confirm all SkyView Network components are found, including ALL displays that
are in the aircraft.
4. If there is another display installed in the aircraft:
a. Using a display that never left the aircraft (and is presumably configured and
working correctly):
i. Reconfigure SkyView Network under SETUP MENU > SYSTEM SETUP >
SKYVIEW NETWORK SETUP > CONFIGURE…
ii. Confirm all SkyView Network components are found.
5. Confirm that all settings, behavior, and configuration are normal.
6. If your SkyView system is not working normally, contact Dynon Avionics Technical
Support (contact information at the beginning of this manual) for further assistance.
SkyView Display Scenario 2: When repaired display is the ONLY display in the aircraft,
and the documentation furnished with the repaired unit indicates that the display
was shipped “like new”
1. Reinstall the display, reconnecting all harnesses and connections as originally installed.
2. Power up the entire SkyView System (all displays, modules, servos, etc.).
3. If you have an EXPORT SETTINGS file on a USB flash drive:
a. Load the EXPORT SETTINGS file via SETUP MENU > SYSTEM SOFTWARE > LOAD
FILES.
b. Confirm that the tail number under SYSTEM SETUP > AIRCRAFT INFORMATION is
now set to the actual aircraft tail number, not DYNON. TAIL NUMBER should not
include dashes (-) or spaces. Examples:
Correct: N12AB
Incorrect: N-12AB or N 12AB
c. Reconfigure SkyView Network under SETUP MENU > SYSTEM SETUP > SKYVIEW
NETWORK SETUP > CONFIGURE…
d. Confirm all SkyView Network components are found.
e. Confirm all settings, calibrations, and behaviors are as expected. Dynon Avionics
recommends using the Installation Guide to walk through each set up section to
confirm proper system operation.
To Next Page
Loading...
