Table 105 – SV-XPNDR-261/262 ADS-B Parameters Supported
In all cases, uncompensated latency due to the transponder is less than 10 milliseconds.
Analysis of the system latency should add this to the latency of the GPS system and the
transmission time of the position data from the GPS to the transponder to determine the
overall latency.
14 CFR § 91.227 Compliance
The Dynon Avionics SV-XPNDR-261 transponder can be connected to the following GPS units to
form the basis of a 14 CFR § 91.227 compliant ADS-B Out installation:
Dynon Avionics SV-GPS-2020 (connected to SkyView display)
Avidyne IFD440/IFD540 (connected directly)
FreeFlight 1201/1204 (connected directly)
Garmin GNS 400W/500W series (connected directly)
Trig Avionics TN70 (connected directly)
For installations seeking certification to 14 CFR § 91.227 or other applicable standards,
additional compliance information may be available on request from Dynon Avionics or Trig
Avionics Limited.
AMC 20-24 Compliance
The Dynon Avionics SV-XPNDR-261 or Dynon Avionics SV-XPNDR-262 transponder can be
connected to the following GPS units to form the basis of an AMC20-24 compliant ADS-B
installation:
Avidyne IFD440/IFD540 (connected directly)
FreeFlight 1201/1204 (connected directly)
Garmin GNS 400W/500W series (connected directly)
Trig Avionics TN70 (connected directly)
For installations seeking certification to AMC 20-24 or other applicable standards, additional
compliance information is available on request from Trig Avionics Limited.
Automatic Air/Ground Determination
The SV-XPNDR-261/262 can report ADS-B surface and airborne messages. This can be
accomplished via a squat switch input that is designed to be used with an automatic air/ground
switching device, or via automatic detection. These options are fully explained in section SV-
XPNDR-261/262 Installation and Configuration of this guide.
To Next Page
Loading...
