Dynon SkyView HDX - SV-ADAHRS-200 Inputs and Sensors

SV-ADAHRS-200 Module Installation and Configuration
SkyView HDX System Installation Manual - Revision E 7-5
The ADAHRS installation location should also adhere to the following requirements:
• Avoid locations that are lower than the lowest point in the AOA/Pitot/Static
system to reduce the chance of allowing moisture to enter the module.
• Avoid locations that are subject to severe vibration.
• Avoid locations that are subject to rapid changes in temperature.
• Avoid locations that are subject to extreme humidity.
• Leave ample working room for electrical and pneumatic connections.
Table 11: SV-ADAHRS-200 Inputs and Sensors describes which sensors and inputs are
used to generate displayed instruments.
Table 11: SV-ADAHRS-200 Inputs and Sensors
Displayed
Instrument
GPS
Pitot
Static
AOA
Internal
Magnet-
ometer
Remote
Magnet-
ometer
Rate
Sensors
Accel-
erometer
OAT
Airspeed
✓
✓
Altitude
✓
Angle of Attack
(AOA)
✓
✓
Attitude
*GPS used only
during Pitot failure
✓*
✓
✓
✓
✓
Ball
✓
Density
Altitude (DA)
✓
Flight Path
Marker (Internal
Magnetometer)
✓
✓
✓
✓
✓
✓
Flight Path
Marker (External
Magnetometer)
✓
✓
✓
✓
✓
✓
Ground
Speed (GND)
✓
Heading (HDG)
(Internal
Magnetometer)
✓
✓
✓
✓
✓
Heading (HDG)
(External
Magnetometer)
✓
✓
✓
✓
✓
Heading (HDG)
(Magnetometer
Fail)
✓
✓
✓
✓
✓
Synthetic Vision
(Internal
Magnetometer)
✓
✓
✓
✓
✓
✓