SV-XPNDR-261 Transponder Installation and Configuration
SkyView HDX System Installation Manual - Revision E 12-25
To update your SV-XPNDR-261, select STATUS and right-click. You will see the screen
shown in the figure below.
Note the reference to “LOAD WILL BE INITIATED BY MASTER SCREEN”. In a SkyView
system, one (1) display is elected “Master” behind the scenes, and the “Master” display
will be the one (1) to actually load the new Software onto the SV-XPNDR-261, which may
not be the display that you began the Software update on (if all displays remained
powered on) – see the tip at the beginning of this procedure to power off all but one (1)
SkyView display.
Figure 82: SV-XPNDR-261 Software Update Ready to Load
To Next Page
Loading...
