the following priority, based on the completeness of the traffic portrait they
provide:
1. SV-ADSB-472 with full traffic (ADS-B ground station reporting with radar
coverage).
2. TIS transponder from SV-XPNDR-261 or Garmin GTX 330 / ES (when in
an active TIS coverage area).
3. FLARM.
4. Zaon.
5. SV-ADSB-472 with No RADAR (ADS-B reception, but without ground
ADS-B station coverage or radar target inclusion).
4.3.9.2 Dynon Avionics SV-XPNDR-261 Transponder
See the SV-XPNDR-261 Transponder Installation and Configuration section for detailed
instructions on how to set up the serial connection to the SV-XPNDR-261.
Note that if you are using a Dynon Avionics SV-XPNDR-261 Transponder, none of the
encoder options in the below sections should to be set for the Dynon Avionics SV-
XPNDR-261 module to receive pressure altitude. Instead, when the SV-XPNDR-261 is
set up as described in the SV-XPNDR-261 Transponder Installation and Configuration
section, it is automatically configured to receive pressure altitude from SkyView.
Alternatively, systems that require the use of an external altitude encoder can be
configured per the following section to have SkyView pass along an external pressure
altitude source.
4.3.9.3 Dynon Avionics SV-ADSB-472
See Section 14 -SV-ADSB-472 ADS-B IN Receiver Installation for detailed instructions
on how to set up the serial connection to the SV-ADSB-472.
4.3.9.4 Garmin GTX 330ES
To enable ADS-B traffic with a Garmin GTX 330ES, both the serial ports transmit and
serial ports receive between SkyView and the GTX 330ES must be connected and
configured. The GTX 330ES must be fully configured to output ADS-B Out, which requires
a TSO’d GPS position. Contact Garmin for correctly configuring the GTX 330ES ADS-B
Out capability. Also see SV-ADSB-472 ADS-B IN Receiver Installation, for additional
configuration.
• SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT
x SETUP > SERIAL IN DEVICE > GARMIN GTX 330ES.
• SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT
x SETUP > SERIAL OUT DEVICE > ICARUS ALTITUDE 100ft OR ICARUS
ALTITUDE 10ft.
• SETUP MENU > SYSTEM SETUP > AIRCRAFT INFORMATION >
TRANSPONDER HEX CODE > (set to same HEX CODE as configured in the
Garmin 330 ES) > ACCEPT (button).
To Next Page
Loading...
