SkyView HDX Display Installation and Configuration
4-20 SkyView HDX System Installation Manual - Revision E
• Set NAVIGATION SOURCE DISPLAY NAME: (user selectable, 7 characters –
suggest NAV2000). The name entered here is displayed as the HSI source and
the Flight Plan Source (if this device outputs a flight plan).
• SETUP MENU > SYSTEM SETUP > DISPLAYED COM: NONE (If a SkyView
compatible COM radio such as the SV-COM-X83 is installed, refer to those
instructions for this setting) and SETUP MENU > SYSTEM SETUP > DISPLAY
COM IN TOP BAR: NO (If a SkyView compatible COM radio such as the SV-
COM-X83 is installed, refer to those instructions for this setting).
4.3.9.11 Garmin SL40 COM Radio
SkyView can display COM radio information from the SL40 on the SkyView top bar and
send COM frequencies to the SL40 (TUNE COM).
• Connect SL40 serial RX pin 10 (RxD1) to a SkyView serial TX. If you have
more than one (1) SkyView display, make the same connection to all SkyView
displays.
• Connect SL40 serial TX pin 3 (TxD1) to one (1) of the SkyView serial RX pins
on each display. If you have more than one (1) SkyView display, make the
same connection to all SkyView displays.
• Ensure there is a shared ground between the SkyView display, and the SL40.
If you have more than one (1) SkyView display, make the same connection to
all SkyView displays.
• Configure the serial port on the SL40 appropriately.
• Configure the serial port: SETUP MENU > SYSTEM SETUP > SERIAL PORT
SETUP > SERIAL PORT x SETUP > SERIAL IN DEVICE > GARMIN /
APOLLO SL40. This will automatically set the SERIAL IN FUNCTION, SERIAL
IN/OUT BAUD RATE, and SERIAL OUT DEVICE.
• Set the SL40 status to be displayed on the top bar: SETUP > SYSTEM SETUP
> DISPLAYED COM > GARMIN / APOLLO SL40 (PORT x) and SETUP MENU
> SYSTEM SETUP > DISPLAY COM IN TOP BAR: YES.
4.3.9.12 Trig TY91 COM Radio
SkyView can display COM radio information from the TY91 on the top bar of the SkyView
display(s) and “push” COM frequencies to the TY91 (TUNE COM).
• Connect TY91 RS232 In (TC90 Pin 6) to a SkyView serial TX. If you have more
than one (1) SkyView display, make the same connection to all SkyView
displays.
• Connect TY91 RS232 Out (TC90 Pin 5) to a SkyView serial RX. If you have
more than one (1) SkyView display, make the same connection to all SkyView
displays.
• Ensure there is a shared ground between the SkyView display and the TY91.
If you have more than one (1) SkyView display, make the same connection to
all SkyView displays.
To Next Page
Loading...
