102 Solution Ultima 844/862/880 Installation Manual
Programming
The programming options of the control panel are stored in a non-volatile EPROM. This memory will
hold all the relevant configuration and user specific data even during a total power loss.
The data retention time is as long as ten years without power; therefore, no reprogramming will be
required after powering the control panel down.
The data can be changed as many times as required without the need for any additional specialised
equipment. This memory is laid out in numerous locations, each of which holds the data for a specific
function.
15 is the maximum value that can be programmed into any location.
In general, the entire programming sequence will consist of nominating the required location number
and then enter or change the current data. You will repeat this procedure until all the data has been
programmed to suit your requirements. The factory default settings have been selected for reporting
to the monitoring station in the Contact ID Format.
The Installers Code only gives access to the Installer's Programming Mode and does NOT arm and
disarm the system. Installer’s Programming Mode can not be entered when the system is armed, or at
any time during siren run time.
Programming of the
Solution Ultima 844/862/880 control panel can be carried out via any of
the following three methods.
• Remote Codepad
• Hand Held Programmer (CC814)
• Alarm Link Upload/Download Software (CC816)
Example
Primary Telephone Number For Receiver 1
LOCATION 000 - 015 0000000000000000
LOCATION 000 LOCATION 004
LOCATION 015
LOCATION 001
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...