158
Solution Ultima 844/862/880 Installation Manual
Access Codes
This section describes the access codes that are used to assign privileges and access functions for user
code holders of the system. Two types of user codes exist within the system, the Installer Code and
User Codes. Each of these codes allow specific access and operation of the varied functions of the
control panel.
Installer Code
LOCATION 181 - 184 1234
This code is used to access the Installer's Programming Mode and can be between one to four digits
long. However, after the control panel has been powered up, the Installer Code can disarm the system
if it is the first code used. The next time the Installer Code is used, access into Installer's
Programming Mode will be made.
Installer Code functions are available to allow the installer to carry out various functions during the
disarmed state without the need to remember the customers Master Code. Refer to Installer Code
Functions on page 62 for more information.
Refer to Programming With The Remote Codepad on page 103 for more information on programming
the system once Installer’s Programming Mode has been accessed.
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...