Domestic Dialling 127
Setting Up and Programming Domestic Reporting
Programming the control panel for domestic reporting has been made extremely simple by the use of
the Installer's Programming Command 965. Refer to Command 965 - Set Up Domestic Dialling
Format on page 114 for more information. However, if you wish to set up Receiver 2 for Domestic
Dialling, you will need to manually program the reporting functions.
How To Set Up The Control Panel For Domestic Dialling
1. Enter Installer's Programming Mode (EG: 1234followed by the button).
Two beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Enter Command
965followed by the button.
Two beeps will be heard. The control panel has now been set up for Domestic Dialling
Format. Refer to Command 965 - Set Up Domestic Dialling Format on page 114 for more
information.
3. Exit Installer's Programming Mode by entering Command 960 followed by the
button. Two beeps will be heard and the
STAY and AWAY indicators will extinguish. The
system will now return to the disarmed state.
4. Enter your
followed by 2and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
If there are telephone numbers programmed, they will be displayed one digit at a time via the
codepad indicators.
If there are no telephone numbers programmed, a further two beeps will be heard after entering
this mode. These two beeps are normally heard after the last digit of the last phone number has
been displayed.
5. Enter all the digits for
, one digit at a time. You will notice as each digit is entered,
the corresponding codepad indicators will illuminate.
6. If there is more than one telephone number, press the
button followed by the 4 button
after the last digit of the telephone number.
number and the second telephone number. If there is only one phone number, press the
button to exit this mode.
his will insert a break between the first telephone T
7. Enter all the digits for
, one digit at a time. You will notice as each digit is
entered, the corresponding codepad indicators will illuminate.
8. After the last digit of the second telephone number, press the button to exit this mode
unless a third telephone number is required. If there is a third telephone number to be
programmed, press the
button followed by the 4 button to insert a break between the
second telephone number and the third telephone.
+
2
+
+
+ +
4
+ +
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...