230 Solution Ultima 844/862/880 Installation Manual
System Options 4
LOCATION 439 0
Option Description
1
Panel To Power Up Disarmed (If Power Reset)
2
Arm/Disarm Tracking On Power Up
4
Internal Crystal To Keep Time
8
Keyswitch Interface, Night Arm Station Or RE005 Installed
1
2
Table 142: System Options 4
Panel To Power Up Disarmed (If Power Reset)
If this option has been selected, the control panel will power up in the disarmed state once the battery
and AC mains have been reconnected after the system has been powered down.
If this option is not selected, the system will always power up armed in AWAY Mode.
Arm/Disarm Tracking On Power Up
If enabled, the control panel will keep its current armed status in non-volatile memory. If for any
reason the control panel is restarted due to a power failure, the control panel will return to the armed
or disarmed status that the control panel was in before the power failed.
Example
If the system was disarmed prior to the system being powered down, when the system is powered
back up, the system will return to the disarmed state.
Internal Crystal To Keep Time
If this option has been selected, it will force the control panel not to use the mains frequency as a time
base to keep time. The control panel will use the internal crystal (XTAL) to keep track of time. This
4
8
option is useful in countries that do not have a constant mains frequency.
Keyswitch Interface, Night Arm Station Or RE005 Installed
This option must be selected when using the Radio Key/Keyswitch Interface (CC813), 2 Channel
Radio Interface (RE005), or the Night Arm Station (CP105). This option allows the control panel to
be operated using any of these three accessories. When using these optional accessories, they will
report as User Code 16.
Using a Solution Ultima 880 control panel that has been partitioned, the Night Arm Station will
not operate the system.
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...