218
Solution Ultima 844/862/880 Installation Manual
Sensor Watch Time
LOCATION 420 - 421 00
Location Description
420
Increments Of Days (Tens Digit)
421
Increments Of Days (Units Digit)
Table 126: Sensor Watch Time Locations
The time set in these two locations determine how many days (0-99) a zone may remain sealed before
registering as a fault. This feature is only active when the system is in the disarmed state. If a zone
programmed for sensor watch has not become unsealed and reset during this time, the
FAULT
indicator will illuminate. Refer to Fault Descriptions on page 53 for further information on sensor
watch faults. Refer to Zone Options 1 on page 175 for programming zones for sensor watch.
The sensor watch time counter is only active whilst the control panel is disarmed. Therefore, if the
system is only disarmed for 8 hours a day and the sensor watch time is programmed for 1 day, a zone
that is programmed for sensor watch will register a sensor watch fault if not triggered during the
disarmed state within 3 days.
This feature would be useful in a situation where someone has moved objects in the view of the
detector, blocking out the detector from picking up movement. Refer to LOCATION 333 - 334 on
page 186 if you wish to disable sensor watch reports.
Codepad Lockout Time
LOCATION 422
Location Description
422
Increments Of 10 Seconds (0 - 150 Seconds)
Table 127: Codepad Lockout Time Locations
All codepads will be locked out for the specified time programmed if an invalid code has been entered
more times than allowed by the code retry attempts programmed in "LOCATION 368 - 370" on page
195. If the Codepad Lockout Time is programmed as zero, no codepad lockout will occur.
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
0
To Next Page
Loading...