Codepad Indicators 37
MAINS Indicator
The MAINS indicator is used to display that the systems AC mains supply is normal or has failed.
When programming numbers (i.e. Installer’s Programming Mode or Master Code Functions), the
MAINS indicator will illuminate when you program numbers between 10 and 15. The MAINS
indicator represents digit 10 plus the value of the illuminated zone indicator (e.g.: If you program a
twelve, the
MAINS indicator and zone 2 will illuminate).
Indicator Definition
On
AC Mains Power Normal
Flashing
AC Mains Failure
Table 22: MAINS Indicator
FAULT Indicator
The FAULT indicator is used to display that the system has detected a fault. Refer to Fault
Descriptions on page 53 for more information on system faults.
Every time a new system fault has been detected (e.g.: FAULT indicator flashing), the codepad will
begin to beep once every minute.
Pressing the
button once will cancel the once a minute beep and acknowledge the fault (e.g.:
FAULT indicator on).
Indicator Definition
On
There Is A System Fault That Needs To Be Rectified
Off
The System Is Normal, There Are No Faults
Flashing
There Is A System Fault Waiting To Be Acknowledged
Table 23: FAULT Indicator
Audible Indicators
In general, the audible indications given out by the codepad are as follows:
Indicator Definition
One Short Beep
A Button Has Been Pressed On The Codepad Or End
Of Exit Time When Armed In Either STAY Mode 1 Or
STAY Mode 2
Two Short Beeps
The System Has Accepted Your Code
Three Short Beeps
The Requested Function Has Been Executed
One Long Beep
Indicates The End Of Exit Time In AWAY Mode Or
The Requested Operation Has Been Denied Or Aborted
One Short Beep Every Second
Walk Test Mode Is Currently Active Or Warning
Before Automatic Arming Takes Place
One Short Beep Every Two
Seconds
Telephone Monitor Mode Is Active
One Short Beep Every Minute
There Is A System Fault Waiting To Be Acknowledged
Table 24: Audible Indications
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...