EDM Solution Ultima 844 - Changing and Deleting User Codes

System Functions 77
Changing and Deleting User Codes
This function allows a Master Code holder to add/change or delete any of the system user codes.
When using a
Solution Ultima 880 control panel that has been partitioned, user codes cannot be
added, changed or deleted by the Master Code holder unless they (the user code) have been allocated
to an area or the same area as the Master Code. Refer to User Code Allocations on page 245 for more
information
How To Add Or Change A User Code
1. Enter your followed by 1and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Enter the
(1-8) that you wish to change followed by the button.
Two beeps will be heard and the corresponding
ZONE indicator will illuminate. Refer to
"Table 37: Codepad Indicators Showing Relative User Numbers" on page 78.
3. Enter the digits required for the
followed by the button.
Two beeps will be heard and the
STAY and AWAY indicators will extinguish.
If you wish to add or change additional user codes, repeat this procedure as many times as
required.
+
1
+
+
+ + +
1
When adding or changing user codes, this function will automatically terminate if a button is
not pressed within sixty seconds or by pressing the button. One long beep indicates the
code entered already exists or an incorrect user number has been selected.
Example
If you wish to program user code number 2 as 4627, follow the steps outlined below and remember to
substitute the default Master Code (2580) with the Master Code that has been programmed.
2580
+
1
+
+
2
+
+
4627
+
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC