System Functions 75
8
Event Memory Recall Mode
This function allows you to playback the last forty events that have occurred to the system. The event
memory recall mode reports all alarms and arming/disarming of the system in the AWAY Mode,
STAY Mode 1 and STAY Mode 2. This function helps with trouble shooting system faults. The
events are displayed via the codepad indicators.
How To Enter The Event Memory Recall Mode
1. Enter your followed by 8and the button.
Three beeps will be heard. The events will be played back via the codepad indicators in
reverse chronological order.
+
8
+
Example
If the events were as follows:
Event No Event Description
1
System Armed In AWAY Mode
2
Alarm In Zone 3
3
Alarm In Zone 4
4
System Disarmed
Table 34: Event Memory Recall - Example Events
The event memory playback will report as follows:
Event No Codepad Indicator Event Description
4
All Indicators Off Except MAINS System Disarmed
3
Zone 4 + AWAY Indicator Illuminates Alarm In Zone 4
2
Zone 3 + AWAY Indicator Illuminates Alarm In Zone 3
1
AWAY Indicator Illuminates System Armed In AWAY Mode
Table 35: Event Memory Recall - Example Event Playback
A beep and an illuminated indicator indicate each event. Resetting a 24-hour alarm in the disarmed
state is indicated by one beep only. After the last event, three beeps will be heard to indicate the end
of playback. The replay of event memory can be terminated at any time by pressing the button.
If the system is armed in STAY Mode 1 or STAY Mode 2, the STAY indicator will display during
the event memory playback. There is no differentiation between arming the system in STAY
Mode 1 and STAY Mode 2.
If the control panel has been powered down, the memory of all events will be lost.
All Solution Ultima 880 control panels that have been partitioned will only replay the last ten
events for each area.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...