System and Consumer Options 227
System Options 1
LOCATION 436 1
Option Description
1
EDM Smart Lockout Allowed
2
Horn Speaker Monitor
4
Strobe Indications For Radio Arm/Disarm
8
Assign Button 4 On Transmitter To Operate STAY Mode 1
1
2
4
Table 138: System Options 1
EDM Smart Lockout Allowed
This feature allows the control panel to remove any zones that are programmed for lockout dialler
from the lockout list while the sirens are running. This feature allows a monitoring station to receive
zone alarm reports from previously locked out zones during siren run time. Refer to Zone Options 1
on page 175 for information on programming zones for lockout dialler and lockout siren.
Refer to Swinger Shutdown Count For Dialler on page 182 to program the number of times the zone
can report before being locked out.
Horn Speaker Monitor
If this option has been selected, the control panel will detect when the horn speaker has been
disconnected from the speaker terminals. The
FAULT indicator will illuminate when the horn speaker
has been disconnected and will extinguish when the horn speaker has been reconnected.
If an output is required to operate when the horn speaker has been disconnected, refer to Output Event
Type – Horn Speaker Monitor Fail on page 204 for more information.
Strobe Indications For Radio Arm/Disarm
This option will allow the strobe to indicate when the system is armed and disarmed when remotely
operating the system via the 304 MHz RF Receiver (RF3212).
No Of Seconds System Status
3 Seconds
System Disarmed
6 Seconds
System Armed In AWAY Mode
6 Seconds
System Armed In STAY Mode 1
Table 139: Strobe Indications For Remote Operations
Assign Button 4 On Transmitter To Arm STAY Mode 1
This option will allow button 4 on the 4 Channel Hand Held Transmitter (RF3334) to arm the system
8
in STAY Mode 1.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...