220
Solution Ultima 844/862/880 Installation Manual
Auto Arming Pre-Alert Timer
LOCATION 425 1
Location Description
425
Increments Of 5 Minutes (0 – 75 Minutes)
Table 130: Auto Arming Pre-Alert Timer Location
This location sets the time period that will warn you before the control panel will automatically arm in
AWAY Mode. The codepad will beep once every second until the pre-alert timer has expired, after
this time, the system will automatically arm itself in AWAY Mode. If you require the system to
automatically arm in STAY Mode 1, enable Option 4 in “LOCATION 440” on page 231.
Once the control panel has automatically armed in AWAY Mode or STAY Mode 1, exit time will
commence. If a valid user code is entered during the pre-alert time, the auto arming time as
programmed in “LOCATION 426 - 429” will extend by one hour.
If you require a programmable output to operate during the auto arming pre-alert time, refer to Output
Event Type – Auto Arm Pre-Arming Alert Time on page 202.
Auto Arming Time
LOCATION 426 - 429 0000
Location Description
426
Actual Hour Of The Day (Tens Digit)
427
Actual Hour Of The Day (Units Digit)
428
Actual Minute Of The Day (Tens Digit)
429
Actual Minute Of The Day (Units Digit)
Table 131: Auto Arming Time Locations
These locations are used to program the actual time of the day that the system will automatically arm
itself in AWAY Mode. This time must be set in 24 hour format (i.e.. 10:30 PM would be
programmed as 2230). Refer to Option 4 in “LOCATION 440” on page 231 if you require the system
to arm in STAY Mode 1.
If forced arming has been disabled for any zone, the feature of automatic arming will operate
regardless of any zones being unsealed. Refer to Zone Options 2 on page 179 for more information
on programming zones for forced arming.
User code 16 will be report when the feature of automatic arming is used.
On
Solution Ultima 880 control panels that have been partitioned into two separate areas, both
areas will automatically arm in AWAY Mode at the same time every day.
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...