EDM Solution Ultima 844 - Delay-1 Zone; Delay-2 Zone; Handover Zone; Instant Zone

Zone Information 171
Zone Types
There are thirteen different zone types to choose from. Refer to the table below for the different zone
types available.
Zone Type Description Zone Type Description
0
Instant
8
24 Hour Hold-Up
1
Handover
9
24 Hour Tamper
2
Delay-1
10
Reserved
3
Delay-2
11
Keyswitch
4
Reserved
12
24 Hour Burglary
5
Reserved
13
24 Hour Fire
6
24 Hour Medical
14
Chime Only
7
24 Hour Panic
15
Zone Not Used
0
1
2
3
4
Table 79: Zone Types
Instant Zone
An Instant zone (Contact ID Event Code 130) will sound the sirens and operate the dialler as soon as
it registers as unsealed after the exit timer has expired.
If an Instant zone has not restored at the time the system is disarmed, a zone restore report will be
automatically sent to the receiving party.
Handover Zone
A Handover zone (Contact ID Event Code 130) will act as an instant zone if it has been triggered by
itself. If a handover zone has triggered after a delay zone, the remaining delay time will handover
from the delay zone to the handover zone. Handover may be sequential or non-sequential. The
control panel is factory default with sequential handover. Refer to Option 8 in "LOCATION 438" on
page 229 if you require handover to be non-sequential.
If a Handover zone has not restored at the time the system is disarmed, a zone restore report will be
automatically sent to the receiving party.
Delay-1 Zone
A Delay-1 zone (Contact ID Event Code 130) will have a delay time determined by the value in Entry
Timer 1 on page 216. After entry time has expired, the system will activate into alarm condition.
If a Delay-1 zone has not restored at the time the system is disarmed, a zone restore report will be
automatically sent to the receiving party.
Delay-2 Zone
A Delay-2 zone (Contact ID Event Code 130) will have a delay time determined by the value in Entry
Timer 2 on page 216. After entry time has expired, the system will activate into alarm condition.
If a Delay-2 zone has not restored at the time the system is disarmed, a zone restore report will be
automatically sent to the receiving party.
Reserved
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC