System Functions 63
Adding Or Deleting RF Wireless Devices
The control panel has the ability to accept a maximum total of 16 wireless devices on any or all of the
8 zones that are used by the system. This means that it is possible to connect wireless PIR's, reed
switches and smoke detectors directly to the control panel. Each zone can have multiple wireless
devices allocated (e.g.: Zone 1 may have 16 wireless devices allocated and the remaining seven zones
are hard wired). Refer to RF Device Mapping (Devices 1 – 8) and RF Device Mapping (Devices 9 –
16) on page 250 for more information.
How To Program A RF Wireless Device
1. Enter your followed by 0and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Enter the
(1-16) that you wish to change followed by the button.
Two beeps will be heard and the corresponding codepad indicators will illuminate to display
the RF device number that you have selected.
3. Enter the
found on the back of the RF device followed by the button.
Two beeps will be heard and the
STAY and AWAY indicators will extinguish.
If you wish to program additional RF wireless devices, repeat this procedure as many times as
required.
+
0
+
+
+ + +
0
When adding RF devices, this function will automatically terminate if a button is not pressed
within sixty seconds or by pressing the button. One long beep indicates the code
entered already exists or an incorrect user number has been selected.
Example
If you require to program RF wireless device number 3 with a 9-digit ID number of 000094946,
follow the steps outlined below and remember to substitute the default Installer Code (1234) with the
Installer Code that you have programmed.
1234
+
0
+
+
3
+
+
000094946
+
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...