System Functions 87
5
How To Disable STAY Mode 2 Zones
If at any time you wish to disable all zones selected to be automatically isolated for STAY Mode 2,
you may enter the following sequence.
+
4
+
+
Turning Outputs On/Off
If an output has been programmed for remote operation, you can turn the remote output on or off
using this Master Code function or remotely using the Alarm Link Software.
For this Master Code Function to operate, one or more programmable outputs will need to be
programmed with one of the following output event types.
Output Number 1 = Output Event Type – 2,8 on page 207.
Output Number 2 = Output Event Type – 2,9 on page 207.
Output Number 3 = Output Event Type – 2,10 on page 207.
How To Turn An Output On From The Remote Codepad
1. Enter your followed by 5and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Enter the required
(1-3) followed by the button.
Three beeps will be heard and the output will now turn on. Repeat step 2 if more than one
output is required to be turned on.
3. Press the
button again to exit this function.
Two beeps will be heard and the
STAY and AWAY indicators will extinguish.
+
5
+
+ + +
Example
If Output 2 has been programmed as 281000in “LOCATION 386 – 391”, the Master Code
holder may turn on this output following the steps outlined below;
2580
+
5
+
+
1
+ +
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...