214
Solution Ultima 844/862/880 Installation Manual
One Shot Polarities
The duration or "On" time of an output is determined by the product of the time base and the
multiplier.
If an output is required to operate for five seconds, program the time settings as follows;
2 0 5
Time Base Multiplier
The "On" time is calculated by multiplying the time base setting (1 second) by the multiplier value
(05).
(i.e.. 1 x 05 = 5 seconds)
On Time Increments Tolerance
200 ms - 19.8 Sec’s 200 ms +/- 200 ms
1 Sec - 99 Sec’s 1 Sec +/- 1 Sec
1 Min - 99 Min’s 1 Min +/- 1 Min
1 Hour - 99 Hours 1 Hour +/- 1 Hour
Table 120: One Shot Time Settings
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...