42 Solution Ultima 844/862/880 Installation Manual
Arming The System In STAY Mode 1
Arming the system in STAY Mode 1 is only used when the perimeter and unused areas of the
premises need to be armed to detect any would be intruder from entering the premises, at the same
time allowing you to move freely within an area which has been automatically isolated.
Only the installer can program zones to be automatically isolated in STAY Mode 1. Refer to Zone
Options 2 on page 179 for further information on setting zones to be automatically isolated in STAY
Mode 1.
There are two methods for arming your system in STAY Mode 1. Method one is standard and will
always operate. Method two is optional and requires Option 2 in "LOCATION 441" to be enabled on
page 232.
When reporting back to base, a “Partial Close” report (Contact ID Event Code 456) will be sent.
Entry Guard Timer For STAY Mode
When arming the system in STAY Mode 1, an optional entry timer called Entry Guard Timer For
STAY Mode may be used to delay the sirens, strobe and bell outputs if a zone that has not been
automatically isolated has triggered into alarm condition. Entry Guard Timer For STAY Mode is the
delay time used for all zones except 24 hour zones when the system is armed in STAY Mode 1 or
STAY Mode 2.
If the Entry Guard Timer For STAY Mode has been programmed and a zone that has not been
automatically isolated has triggered, the codepad will beep twice a second until the Entry Guard Timer
For STAY Mode has expired or the system has been disarmed. If the alarm condition has not been
reset before Entry Guard Timer For STAY Mode expires, the strobe, bell and siren outputs will
activate into alarm.
Single button arming in STAY Mode 1 will report as user code number 16.
Method One
How To Arm The System In STAY Mode 1
1. Enter your followed by the button.
Two beeps will be heard and the
STAY indicator will illuminate. Exit time will now
commence.
Any zones that have been programmed to be automatically isolated in STAY Mode 1 will
begin to flash until exit time expires. At the end of exit time, the
ZONE indicators will
extinguish and the codepad will give one short beep.
+
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...