System Functions 79
Changing and Deleting Remote Radio User Codes
This function allows a Master Code holder to add/change or delete any of the system user codes.
How To Add Or Change A Remote Radio User Code
1. Enter your followed by 1and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Enter the
(9-16) that you wish to change followed by the button.
Two beeps will be heard and the corresponding codepad indicators will illuminate. Refer to
"Table 38: Codepad Indicators Showing Relative Remote User Numbers" on page 80.
3. Enter the
found on the back of the radio remote hand held Transmitter followed
by the # button. Two beeps will be heard and the
STAY and AWAY indicators will extinguish.
If you wish to add additional remote radio user codes, repeat this procedure as many times as
required.
+
1
+
+
+ +
1
When adding or changing remote radio user codes, this function will automatically terminate if
a button is not pressed within sixty seconds or by pressing the button will also terminate
the session at anytime. One long beep indicates the code entered already exists or an incorrect
user number has been selected.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...