EDM Solution Ultima 844 - Page 78

78 Solution Ultima 844/862/880 Installation Manual
How To Delete A User Code
1. Enter your followed by 1and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Enter the (1-8) that you wish to delete followed by the button.
Two beeps will be heard and the corresponding
ZONE indicator will illuminate. Refer to
"Table 37: Codepad Indicators Showing Relative User Numbers" on page 78.
3. Press the
button to delete the user code.
Two beeps will be heard and the
STAY and AWAY indicators will extinguish.
If you wish to delete additional user codes, repeat this procedure as many times as required.
+
1
+
+ + +
When deleting user codes, this function will automatically terminate if a button is not pressed
within sixty seconds or by pressing the button. One long beep indicates an incorrect
user number has been selected.
User
No
Zone 1
Indicator
Zone 2
Indicator
Zone 3
Indicator
Zone 4
Indicator
Zone 5
Indicator
Zone 6
Indicator
Zone 7
Indicator
Zone 8
Indicator
1

2

3

4

5

6

7

8

Table 37: Codepad Indicators Showing Relative User Numbers
Example
If you wish to delete user code number 3, follow the steps outlined below and remember to substitute
the default Master Code (2580) with the Master Code that has been programmed.
2580
+
1
+
+
3
+
+
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited