44 Solution Ultima 844/862/880 Installation Manual
Disarming The System From STAY Mode 1
There are two methods for disarming the system from STAY Mode 1. Method one is standard and
will always operate. Method two is optional and needs Option 4 to be enabled in "LOCATION 441"
on page 232.
Method One
How To Disarm The System From STAY Mode 1
1. Enter your followed by the button.
Two beeps will be heard and the
STAY indicator will extinguish. The system is now disarmed.
+
Method Two
A flashing ZONE indicator represents a previous alarm on that zone. If this is the case, a valid user
code will need to be used to disarm the system using method one. To enable method two, Option 4 in
"LOCATION 441" on page 232 will need to be enabled.
How To Disarm The System From STAY Mode 1
1. Hold down the button until two beeps are heard.
The
STAY indicator will extinguish and the system is now disarmed.
Single button disarming from STAY Mode 1 will report as user code number 16.
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...