Programming 113
Command 964 - Erase Programming Key
This command erases all data from the programming key. Only the Programming Key (CC891) may
be used with the
Solution Ultima 844/862/880 control panel.
How To Erase The Programming Key
1. Enter Installer's Programming Mode (i.e.. 1234followed by the #button).
Two beeps will be heard and the
STAY and AWAY indicators will begin to flash on the remote
codepad to indicate that you have entered Installer’s Programming Mode. You will also notice
that the remote codepad will display the data currently programmed in “LOCATION 000”.
2. Connect the programming key onto the pins marked PROGRAMMING KEY on the control
panel found at the top of the PCB (printed circuit board) next to the Auxiliary Module socket.
3. Enter command
964followed by the #button.
Two beeps will be heard after the programming keys data has been deleted.
4. Before removing the programming key from the control panel, enter command
960
followed by the
# button to exit Installer's Programming Mode. The STAY and AWAY
indicators will now extinguish on the remote codepad and the system will return to the
disarmed state.
Failing to exit Installer’s Programming Mode before removing the programming key may
result in corrupting the programming key.
How To Erase The Programming Key Using The Hand Held Programmer
1. Before connecting the hand held programmer onto the pins marked PROGRAMMING KEY,
make sure that the switch on the hand held programmer is in the EXT position and that no
external key has been plugged onto the hand held programmer.
2. Enter Installer's Programming Mode (i.e..
1234followed by the #button).
Two beeps will be heard and the hand held programmer will display the data currently
programmed in “LOCATION 000”.
3. Plug the programming key onto the pins marked EXTERNAL KEY on the hand held
programmer.
4. Enter command
964followed by the #button.
Two beeps will be heard after the programming keys data has been deleted.
5. Before removing the programming key from the hand held programmer, enter command
960followed by the #button to exit Installer's Programming Mode. Two beeps will be
heard and the system will now return to the disarmed state.
Failing to exit Installer’s Programming Mode before removing the programming key may
result in corrupting the programming key.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...