48
Solution Ultima 844/862/880 Installation Manual
Isolating Zones
Isolating zones allow you to manually disable one or more zones before arming the system in AWAY
Mode, STAY Mode 1 or STAY Mode 2. Once a zone has been isolated, access is allowed into that
zone during the armed state without activating the sirens or dialler.
An example when you may require to isolate a zone before arming in AWAY Mode, STAY Mode 1
or STAY Mode 2 may be when a zone PIR detector may be false alarming or that you may need to
leave a pet inside a particular zone whilst you are away.
Isolating zones is performed by one of two methods. One way requires the use of a valid user code
while the other way does not. The ability to isolate zones is governed by the priority level allocated to
each user code holder. Some user code holders may not be able to isolate zones. Refer to User Code
Priority on page 161 for further information. At factory default, the standard method for isolating
zones is used.
Zones that have been manually isolated using this method will send a zone bypass report (Contact ID
Event Code 570) for each zone upon arming the system. A zone bypass restore report will be sent
when the system has been disarmed.
When you select a 24-hour burglary zone to be isolated, a Contact ID Event Code 572 will be sent. If
you select a 24-hour fire zone to be isolated, a Contact ID Event Code 571 will be sent.
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...