System Functions 73
6
Turning Telephone Monitor Mode On/Off
Telephone monitor mode allows the remote codepad to be used for a visual representation of data
transmissions between the control panel and the base station receiver. The dialling sequence is also
shown in this mode.
The codepad will beep once every two seconds while telephone monitor mode is active regardless of
whether the system is in Installer's Programming Mode or normal operating mode. The first five
indicators are used to display the progressive steps for a transmission to the base station receiver.
After you enter telephone monitor mode, hold down button
9 until two beeps are heard to initiate a
test report.
Zone Indicator Dialling Event
1
Telephone Line Seized
2
Dialling Phone Number
3
Handshake Received
4
Data Is Being Sent
5
Kiss-Off Received
None
Telephone Line Released
Table 33: Telephone Monitor Mode Indications
How To Turn Telephone Monitor Mode On
1. Enter your followed by 6and the button.
Three beeps will be heard.
2. Hold down button
9until two beeps are heard to initiate a test report.
How To Turn Telephone Monitor Mode Off
1. Enter your followed by 6and the button.
Two beeps will be heard.
+
6
+
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...