EDM Solution Ultima 844 - Change Telco Arm;Disarm Sequence

System Functions 83
3
Change Telco Arm/Disarm Sequence
This feature allows you to program the Telco Arm Sequence (Option 1) and Telco Disarm Sequence
(Option 2). This feature is only available if your telecommunication provider has the call forward
option available
Option 1 – Telco Arm Sequence
This allows you to program the Call Forward – Immediate On sequence or Call Forward – No Answer
sequence that will automatically operate when you arm the system in AWAY mode.
Note: The examples given in this feature are only applicable to Australia.
Call Forward – Immediate On
You can redirect calls to anywhere in Australia, including mobiles, pagers and answering services.
When Call Forward – Immediate On is turned on, your telephone will not ring.
Call Forward – No Answer
When you telephone is not answered within 20 seconds, this feature redirects all incoming calls to
another number anywhere in Australia.
Option 2 – Telco Disarm Sequence
This allows you to automatically disable the call forward sequence upon disarming the system.
Contact your telecommunications provider for more information on Call Forward operations.
Digit Required Number To Program Digit Required Number To Program
0
0
8
8
1
1
9
9
2
2
3
3
*
Followed By 1
4
4
#
Followed By 2
5
5
Four Second Pause
Followed By 3
6
6
Break
Followed By 4
7
7
15
Followed By 5
Table 41: Telco Arm/Disarm Dialling Digits
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC