EDM Solution Ultima 844 - Call Back Telephone Number; Telco Arming - Call Forward Immediate off; Telco Arming - Call Forward no Answer off; Telco Disarming Sequence

Dialler Information 147
Telco Disarming Sequence
LOCATION 143 – 158 0000000000000000
These locations allow you to automatically deactivate call diversion on your telephone when you
disarm the system from AWAY Mode.
Digit Required Number To Program Digit Required Number To Program
Terminator
0
8
8
1
1
9
9
2
2
0
10
3
3
*
11
4
4
#
12
5
5
Four Second Pause
13
6
6
Break
14
7
7
15
15
Table 67: Telco Arm/Disarm Dialling Digits
Telco Arming – Call Forward Immediate Off
To turn Call Forward Immediate Off:
#21#
Example
If you wish to disable the Telco Arming – Call Forward Immediate upon disarming the system from
AWAY Mode, you would program the following:
21 000000000000
Telco Arming – Call Forward No Answer Off
To turn Call Forward No Answer Off:
#61#
Example
If you wish to disable the Telco Arming – Call Forward No Answer upon disarming the system from
AWAY Mode, you would program the following:
61 000000000000
Call Back Telephone Number
LOCATION 159 - 174 0000000000000000
This location contains the telephone number that the control panel will dial when Upload/Download is
requested or the number
6 button is held down to initiate a modem call from the control panel to
establish a communications link with the remote computer. The computer must be running the Alarm
Link Software (CC816) and will need to be set to "Waiting For An Incoming Call". The Call Back
Telephone Number is also required to be programmed if Remote Connect With Call Back Verification
on page 123 is required.
Refer to the section - Alarm Link Operations beginning on page 121 for more information.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC