242 Solution Ultima 844/862/880 Installation Manual
4
8
Reset Sirens From Any Area Allowed
This option is only applicable when the control panel has been partitioned. If this option has been
enabled, any valid user code from either Area 1 or Area 2 will be able to reset the horn speaker,
strobe, bell or EDMSAT outputs from operating. This option does not allow a user code allocated
from one area to disarm another area.
Master Codepad To Display AUX Indicator When On-Line
If this option has been enabled, the AUX indicator on the CP5 Master Partitioned (CP500P) codepad
will illuminate when the control panel has seized the telephone line to send a report. The
AUX
indicator will extinguish once the telephone line has been released.
Partitioning Options 2
LOCATION 445
Option Description
1
Lock Area 1 To Receiver 1 and Lock Area 2 To Receiver 2
2
User Code Allowed To Arm/Disarm Both Areas At Same Time (Code + 0 + #)
4
Reserved
8
Reserved
1
2
4
8
Table 156: Partitioning Options 2
Lock Area 1 To Receiver 1 and Lock Area 2 To Receiver 2
If this option has been selected, it will automatically set all reports for Area 1 to Receiver 1 and all
reports for Area 2 to Receiver 2.
If this option has not been selected, all reporting will need to be manually programmed to report on
Receiver 1 or Receiver 2 for both areas.
User Code Allowed To Arm/Disarm Both Areas At Same Time
If this option has been selected, it will allow any user allocated to both areas to arm or disarm both
areas at the same time without the need to enter the code at each area codepad. Refer to Arm or
Disarm Both Areas At The Same Time on page 76 and 92 for more information.
If the user arms both areas at the same time, if in “LOCATION 444” on page 241 has the option “First
To Open/Last To Close Reporting” enabled, only a closing report for the Area 2 will be reported.
If the user disarms both areas at the same time, if in “LOCATION 444” on page 241 has the option
“First To Open/Last To Close Reporting” enabled, only an opening report for Area 1 will be reported.
Reserved
Reserved
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
0
To Next Page
Loading...