94 Solution Ultima 844/862/880 Installation Manual
0
Arm The System In STAY Mode 2
Holding the 0button down until two beeps are heard will arm the system in STAY Mode 2. Option
2 in "LOCATION 441" on page 232 will need to be enabled for this function to operate.
If there has not been an alarm during the armed cycle, holding the
0button down a second time will
disarm the system from STAY Mode 2. If you require single button disarming from STAY Mode 2
using this hold down function, Option 4 in "LOCATION 441" on page 232 will need to be enabled.
If an alarm has occurred or entry warning has been triggered, a valid user code will need to be used to
disarm the system.
Refer to Setting STAY Mode 2 Zones using the Installer Code function on page 71 or Setting STAY
Mode 2 Zones using the Master Code function on page 86 for more information.
STAY Mode 2 is not available to Solution Ultima 880 control panels that have been partitioned.
1
2
3
Horn Speaker Test
Holding the 1 button down until two beeps are heard will sound the horn speaker for a two-second
burst. No other sounding device will sound in this mode.
Bell Test
Holding the 2 button down until two beeps are heard will sound the internal screamers for a two-
second burst. No other sounding device will sound in this mode.
If an EDMSAT (SS914) has been connected to the control panel, this function will test both the horn
speaker and the strobe connected to the satellite siren for two seconds.
Strobe Test
Holding the 3button down will operate the strobe. No other device will operate in this mode.
If an EDMSAT (SS914) has been connected to the control panel, this function will also test the strobe
on the satellite siren.
How To Turn Strobe Test ON
1. Hold down the 3button until three beeps are heard.
The strobe will begin to flash.
How To Turn Strobe Test OFF
1. Hold down the 3button until two beeps are heard.
The strobe will stop flashing.
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...