System Functions 95
4
5
Turning Day Alarm On and Off
Holding the 4 button down will turn day alarm on or off. If the STAY indicator is required to
indicate the status of day alarm operation (enabled/disabled), refer to Option 8 in "LOCATION 440"
on page 231 for further information. The
STAY indicator when enabled, will flash once every 3
seconds to display when day alarm is active.
How To Turn Day Alarm ON
1. Hold down the 4button until three beeps are heard.
Day alarm has now been turned on.
How To Turn Day Alarm OFF
1. Hold down the 4button until two beeps are heard.
Day alarm has now been turned off.
Fault Analysis Mode
There are various system faults that can be detected by the control panel. When any of these faults are
present, the
FAULT indicator will begin to flash and the codepad will beep once every minute. Refer
to Fault Descriptions on page 53 for a more detailed description on each fault type.
How To Determine The Type Of Fault
1. Hold the 5button down until two beeps are heard.
The
STAY and AWAY indicators will begin to flash in unison with the FAULT indicator. One
or more
ZONE indicators (1-8) will illuminate to indicate the type of fault that has occurred.
How To Exit Fault Analysis Mode
1. To exit fault analysis mode, press the button.
The
STAY and AWAY indicators will extinguish and return you to the disarmed state.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...