System Reporting Information 193
System Status – AC Fail Report
LOCATION 360 - 361 2
Location Description
360
System Status – AC Fail Reporting Code (Tens Digit)
361
System Status – AC Fail Reporting Code (Units Digit)
Table 108: System Status – AC Fail Report Locations
An "AC Loss" report (Contact ID Event Code 301) will be sent to the base station receiver when the
AC mains supply has been disconnected continuously for two minutes. If you require an "AC Loss"
report to be sent to the base station receiver when the AC mains supply has been disconnected for 1
hour, enable Option 1 in "LOCATION 438" on page 229. If you wish to ignore AC fail, enable
Option 2 in "LOCATION 438" on page 229.
If an "AC Loss" report is not required, program "LOCATION 360 - 361" with a zero.
System Status – AC Fail Restore Report
LOCATION 362 - 363
Location Description
362
System Status – AC Fail Restore Reporting Code (Tens Digit)
363
System Status – AC Fail Restore Reporting Code (Units Digit)
Table 109: System Status – AC Fail Restore Report Locations
A restore signal will be sent when the AC mains supply has been restored continuously for more than
two minutes.
If an "AC Loss” restore report is not required, program "LOCATION 362 - 363" with a zero.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
7
To Next Page
Loading...