Programming 115
Command 966 - Enable/Disable Automatic Stepping Of Locations
This command allows automatic stepping of locations while programming via Installer’s
Programming Mode. When enabled via the hand held programmer, the decimal point of the left most
display will reflect the mode of operation.
If the decimal point is illuminated on the hand held programmer, automatic stepping of locations is
active. An automatic increment of the location being programmed will occur as soon as the
*button
is pressed positioning you at the next location ready for programming.
If the decimal point is not illuminated on the hand held programmer, the automatic stepping of
locations is disabled and programming the next location will need to be manually selected by pressing
the
# button. As you can see from the examples below, auto step mode can be very useful when
programming successive locations.
When programming via the remote codepad, there are no visual indications to display if automatic
stepping of locations has been enabled.
How To Enable Automatic Stepping Of Locations
1. Enter Installer’s Programming Mode (i.e.. 1234followed by the #button).
Two beeps will be heard.
If you are using the remote codepad, the
STAY and AWAY indicators will begin to flash to
indicate that you have entered Installer’s Programming Mode. You will also notice that the
remote codepad will display the data currently programmed in “LOCATION 000”.
2. Enter command
966followed by the #button.
Two beeps will be heard.
How To Disable Automatic Stepping Of Locations
1. Enter command 966followed by the #button.
Two beeps will be heard.
Example
(Auto Step Enabled)
To enter the Primary Telephone Number "02 pause 9672 1055" with auto step enabled (i.e.. Decimal
point illuminated when using the hand held programmer).
Press
0followed by the #button.
(This will position you at "LOCATION 000" being the start of the Primary Telephone Number For
Receiver 1).
+
*
+
2
+
*
+ +
*
+
9
+
*
+
6
+
*
+
7
+
*
+
2
+
*
+
1
+
*
+ +
*
+
5
+
*
+
5
+
*
+
0
+
*
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...