System Functions 89
6
Setting The Date and Time
This function only needs to be used when the date and time requires to be changed or the system has
been powered down.
If the date and time has not been set using this function, the date and time fault will only display when
the Auto Arming Time in “LOCATION 426 - 429” on page 220 has been programmed, or when you
enter Fault Analysis Mode by holding down the
5button.
How To Set The New Date and Time
1. Enter your followed by 6and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Enter the day, month, year, hour and minute using the (DD, MM, YY, HH, MM) format (i.e..
DD = Day of the month, MM = Month of the year, YY = Current year, HH = Hour of the day,
MM = Minute of the day).
Please note that when programming the hour of the day, you will need to use 24:00 hour
format.
3. Press the
button when finished.
Two beeps will be heard and the
STAY and AWAY indicators will extinguish. If a long beep is
heard, an error was made when entering the date and time.
+
6
+
DD
+
MM
+
YY
+
HH
+
MM
+
Example
If the date and time needs to be set for the 1st February 1997 at 10:30 PM, program the date and time
as follows;
2580
+
6
+
01
+
02
+
97
+
22
+
30
+
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...