88 Solution Ultima 844/862/880 Installation Manual
How To Turn An Output Off From The Remote Codepad
1. Enter your followed by 5and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Enter the required (1-3) followed by the button.
Two beeps will be heard and the output will now turn off. Repeat step 2 if more than one
output is required to be turned off.
3. Press the
button again to exit this function.
Two beeps will be heard and the
STAY and AWAY indicators will extinguish.
+
5
+
+ + +
Example
If Output 2 has been programmed as 281000in “LOCATION 386 – 391”, the Master Code
holder may turn off this output following the steps outlined below;
2580
+
5
+
+
1
+ +
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...