254 Solution Ultima 844/862/880 Installation Manual
Optional Equipment
EDM manufactures numerous accessories that can be used in conjunction with the Solution Ultima
844/862/880
control panel. These optional pieces of equipment will enhance certain features thus
making the system extremely flexible.
2 Channel/4 Channel Hand Held Transmitters 304 MHz (RE012/RE013)
These hand held radio Transmitters can be used in conjunction with the 304 MHz RF Receiver
(RE005) to remotely operate the system. Both hand held Transmitters have the ability to remotely
arm and disarm the system in AWAY Mode or STAY Mode 1 and activate remote panic alarms. The
4 channel hand held Transmitter has the added ability to operate outputs such as garage doors,
swimming pool pumps or outside lights etc.
2 Channel Radio Interface (RE005)
The EDM 2 channel radio interface has been designed to allow customers to remotely operate
Solution control panels and control two on-board relays. The interface may also be used as a stand
alone receiver, independent of a Solution control panel and used solely for remote control of external
devices connected to the two on-board relays.
The interface’s operating frequency is 304 MHz with the ability to store up to 120 radio remote codes.
When connecting the interface to a Solution control panel, there is only a three wire connection in
parallel to the codepad and Option 8 in “LOCATION 439” on page 230 needs to be programmed.
EDMSAT - Satellite Siren (SS914)
The EDMSAT Satellite Siren is a totally self contained unit incorporating a high powered siren and a
weatherproof strobe. A 1.2 AH sealed lead acid battery needs to be fitted. The EDMSAT requires
only two wires for operation on which the charging of the battery and triggering of the siren and
strobe are carried out. This is done by pulse code modulating (PCM) the charging voltage. Any
attempt to tamper with the wiring or to substitute an alternative power source across the wiring will
disrupt the data transmission and the EDMSAT will activate immediately. When the EDMSAT
carries out a battery test, the unit will sound for two seconds if the battery test fails. Refer to the
Output Event Type – EDMSAT - Satellite Siren on page 202 when programming a programmable
output for the satellite siren.
Hand Held Programmer (CC814)
The hand held programmer is used to program the locations in the Solution Ultima
844/862/880 control panel. The unit displays the actual location number and the data value
currently programmed. It comes complete with a one metre connecting cable and a socket for an
external programming key. Refer to Programming With The Hand Held Programmer on page 105 for
more information.
Programming Key (CC891)
The programming key is a unique device that will store all programming information programmed in
your control panel once copied to the programming key. The programming key can hold all your
common configuration data such as monitoring station telephone numbers and zone reporting
channels etc.
Alarm Link Software (CC816)
This software package is designed to be used for programming the Solution Ultima
844/862/880 control panel by either the direct connect method or the remote connect method via
the telephone line. All options and features can be accessed using this software as well as maintaining
history and service reports. Refer to "LOCATION 180" on page 124 or 156 to enable this feature.
Refer to Alarm Link Software on page 122 for more information on the remote connect methods.
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...