Optional Equipment 255
CP5 Eight Zone LED Codepad (CP508)
This codepad is designed to operate with the Solution range of control panels. This codepad
provides indications for up to 8 zones. This codepad cannot be used with the
Solution Ultima
880
control panel when partitioned.
CP5 Eight Zone LCD Codepad (CP508L)
This codepad is designed to operate with the Solution range of control panels with a fixed icon
display. This codepad provides indications for up to 8 zones. This codepad cannot be used with the
Solution Ultima 880 control panel when partitioned.
CP5 Eight Zone Area Addressable Codepad (CP500A)
This codepad is designed to operate with the Solution Ultima 880 control panels when
partitioned. These codepads have DIP switches on the back of the codepad to select which area in
partitioning that the codepad belongs to. Refer to Setting Up and Programming Codepads For
Partitioning on page 246 and Codepad Connections For Partitioning on page 247 for more
information.
CP5 Master Partitioned Codepad (CP500P)
This codepad is designed to operate with the Solution Ultima 880 control panels when
partitioned.
the user to tog
These codepads allow the entire system to be operated from the single codepad allowing
gle between separate areas by pressing the button. This means that there is no
need to have separate CP5 Area Addressable (CP500A) codepads for each area. Refer to Setting Up
and Programming Codepads For Partitioning on page 246 and Codepad Connections For Partitioning
on page 247 for more information.
Night Arm Station (CP105)
The night arm station incorporates a panic button and is designed to allow system operation from a
bedroom or sitting room to arm and disarm the system in STAY Mode 1. Refer to Option 8 in
“LOCATION 439” on page 230 to enable the night arm station to operate with the system.
Phone Controller (CC911)
The phone controller operates at a frequency of 1400 Hz and allows the user to remotely arm the
system in AWAY Mode via the telephone. This phone controller can also be used to acknowledge a
phone call from the control panel when the system is set up for domestic dialling.
Hand Held Dialler Tester (DD901)
The hand held dialler tester simulates a base station for testing of the control panel's dialling functions.
It communicates in most formats.
Cellular Diallers
The cellular dialler when connected to the control panel will send alarm information via the cellular
phone network to the base station receiver when a land telephone line is not present or has been
tampered with.
PS100 Power Supply Module (PS100)
The PS100 Power Supply Module has been designed for applications requiring 13.8 volts DC at
currents of up to 1 Amp and must be used in conjunction with the TF008 - 18 volt AC plug pack.
The unit comes complete with our standard, fully short circuit proof, power out and battery charging
terminals as well as a DC LED indicator and AC mains fail output. For situations requiring an
uninterrupted power source, a rechargeable sealed lead-acid battery can be connected. In the event of
an AC mains failure, the power supply will switch to battery power without interrupting the load
being supplied.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...