142 Solution Ultima 844/862/880 Installation Manual
Primary Telephone Number For Receiver 2
LOCATION 040 - 055 0000000000000000
When the control panel requires to send a report, the control panel will dial this number in an attempt
to contact the monitoring station or pager etc. If the call is successful, the relevant information will be
sent and the dialler will return back to the stand-by mode.
If unsuccessful, the dialler will attempt two more times using the primary telephone number for
Receiver 1, after which the secondary telephone number for Receiver 1 will be called three times. If
the dialling sequence is still unsuccessful, the control panel will then attempt to repeat this procedure
dialling the primary telephone number and the secondary telephone number for Receiver 2 if
programmed.
This procedure will be repeated only once again (i.e.. Maximum of 12 call attempts per alarm) after
ten minutes if none of the first 6 attempts were successful if only the primary telephone number and
secondary telephone number for Receiver 1 has been programmed.
If the primary telephone number and secondary telephone numbers for both Receiver 1 and Receiver 2
have been programmed, a maximum of 24 call attempts per alarm will be made.
Contact your monitoring station or pager company for the relevant telephone numbers before
programming these locations.
When Receiver 2 has been set up for domestic reporting, telephone numbers programmed into
these locations will be ignored. Refer to Changing Domestic Phone Numbers on page 66 when
using the Installer Code function and Changing Domestic Phone Numbers on page 81 when
using the Master Code function.
Secondary Telephone Number For Receiver 2
LOCATION 056 - 071 0000000000000000
Refer to the Primary Telephone Number For Receiver 2 on page 142 for more information.
When Receiver 2 has been set up for domestic reporting, telephone numbers programmed into
these locations will be ignored. Refer to Changing Domestic Phone Numbers on page 66 when
using the Installer Code function and Changing Domestic Phone Numbers on page 81 when
using the Master Code function.
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...