System Event Timers 217
Exit Time
LOCATION 414 – 415 (Defaulted To 60 Seconds) 3
Location Description
414
Increments Of 1 Second (0 - 15 Sec’s)
415
Increments Of 16 Seconds (0 –240 Sec’s)
Table 123: Exit Time Locations
Exit time can be programmed between 0 and 255 seconds in increments of one second. When arming
the system in AWAY Mode, the remote codepad will beep during exit time until the remaining 10
seconds where the codepad will give you one continuous beep to inform you that the end of exit time
is approaching.
The remote codepad will always give one short beep at the end of exit time when arming in STAY
Mode 1 or STAY Mode 2.
Entry Guard Timer For STAY Mode
LOCATION 416 - 417 (Defaulted To 00 Seconds) 00
Location Description
416
Increments Of 1 Second (0 - 15 Sec’s)
417
Increments Of 16 Seconds (0 –240 Sec’s)
Table 124: Entry Guard Timer For STAY Mode Locations
"Entry Guard Timer For STAY Mode" is the delay time used for ALL zones except 24 hour burglary
and 24 hour fire zones when the system is armed in STAY Mode 1 or STAY Mode 2. Each zone
including delay zones will have the entry delay as programmed in "LOCATION 416 - 417" (i.e.. The
entry guard timer will override the delay time programmed for a delay zone). If the entry guard timer
has been programmed as "0" each zone will act as per its programmed zone type.
Refer to Zone Options 2 on page 179 to program zones to be automatically isolated in STAY Mode 1.
Refer to Setting STAY Mode 2 Zones on page 86 to program zones to be automatically isolated in
STAY Mode 2 via the Master Code.
Delay Alarm Reporting Time
LOCATION 418 – 419 (Defaulted To 00 Seconds) 00
Location Description
418
Increments Of 1 Second (0 - 15 Sec’s)
419
Increments Of 16 Seconds (0 –240 Sec’s)
Table 125: Delay Alarm Reporting Time Locations
These locations programs the time in seconds that a delayed report waits dormant in the dial buffer
before reporting to the receiving party. If a user code holder resets the alarm condition within this
time frame, the control panel will clear the dialler buffer and prevent the alarm from reporting to the
receiving party. Refer to Zone Options 1 on page 175 to program zones for delay alarm reporting.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...