Zone Information 165
Day Alarm Operation
If a zone has been programmed for day alarm, the zone can be isolated in the normal way so that it
does not register as a day alarm zone during the disarmed state. Only zones 1 – 4 can be used as day
alarm zones.
The
STAY indicator can be programmed to indicate whether day alarm has been turned on or off.
When day alarm has been turned on, the
STAY indicator will flash once every three seconds. Refer to
Option 8 in “LOCATION 440” on page 231 for more information.
Monitoring of zones 5 – 8 can be achieved by programming an output to mimic a zone. Refer to
Output Event Types on page 202 for more information on all available output types that can be
programmed.
How To Turn Day Alarm On
1. Hold down the 4button until three beeps are heard.
How To Turn Day Alarm Off
1. Hold Down the 4button until two beeps are heard.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...