System and Consumer Options 233
Consumer Options 3
LOCATION 442 5
Option Description
1
Codepad Fault Alarm Beeps Allowed
2
Use Digit 3 For Codepad Duress Instead Of Digit 9
4
Alarms Activate Siren and Strobe Outputs In STAY Mode 1 & 2)
8
Zone Tamper Alarms To Be Silent
1
2
4
8
Table 145: Consumer Options 3
Codepad Fault Alarm Beeps Allowed
If this option has been enabled, the codepad will flash the FAULT indicator and beep once every
minute until acknowledged when a system fault has occurred. To acknowledge a new fault and stop
the codepad from beeping once every minute, simply press the
button.
If this option has not been enabled, the codepad will only flash the
FAULT indicator when a new fault
has occurred, but will not cause the codepad to beep once every minute until the fault has been
acknowledge or rectified.
Use Digit 3 For Codepad Duress Instead Of Digit 9
This option if selected, will allow the customer to use the digit 3after entering their code to disarm
the system to activate a duress alarm.
Alarms Activate Siren & Strobe In STAY Mode 1 & 2
This option will need to be selected if audible alarms are required when the system has been armed in
STAY Mode 1 or STAY Mode 2.
Zone Tamper Alarms To Be Silent
This option allows tamper alarms when using Option 14 in LOCATION 266 on page 166 or the
tamper alarms on RF wireless devices to be silent when triggered into alarm condition.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...