System Functions 97
Codepad Buzzer Tone Change
8
Holding the 8 button down continuously will change the tone of the buzzer in the remote codepad.
There are fifty different tones to choose from between 1500 Hz - 5000 Hz and they are specific to
each codepad. In a multiple codepad installation, each codepad can have a different tone.
How To Change The Tone Of The Buzzer
1. To change the tone of the codepad buzzer, hold the 8button down continuously.
The tone of the buzzer will start to increase in pitch.
2. Release the
8button when the desired tone has been reached.
Every time the system has been powered down, each codepad will need their individual tone
reset using this function.
How To Determine The Area That The Codepad Belongs To
When using Hold Down Function 8 on Solution Ultima 880 control panels that have been
partitioned, the codepad will indicate the area that the codepad belongs to.
1. Hold the
8button down until two beeps are heard.
2. A
ZONE indicator will illuminate to indicate which area that the codepad belongs to when the
system has been partitioned.
Zone 1 = Area 1 Codepad
Zone 2 = Area 2 Codepad
Zone 7 = Master Partitioned Codepad
No
ZONE indicator means that the codepad has incorrect settings or incorrect codepad used.
3. Press the
button to exit this mode.
Send Test Report
9
Holding the 9button down until two beeps are heard will send a test report (Contact ID Event Code
602) that is used to test the dialling and reporting capabilities of the system without causing the sirens
to sound.
A test report will not be sent if the Subscriber ID Number is 0000. This feature is only applicable if
the control panel has been programmed to report via the telephone.
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...