EDM Solution Ultima 844 - Page 84

84 Solution Ultima 844/862/880 Installation Manual
How To Program Telco Arming Sequence
1. Enter your followed by 3and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Press button
1 followed by the button to change the telco arm sequence. Three beeps
will be heard.
If a previous call forwarding sequence has already been programmed, the sequence will be
displayed one digit at a time via the remote codepad indicators.
If there is no call forward sequence programmed, a further two beeps will be heard after
entering this mode. These two beeps are normally heard after the last digit of the call forward
sequence has been displayed.
3. Enter the call forward sequence that you require (e.g.: *61 Phone Number # if you wish to
program the Call Forward – No Answer sequence or *21 Phone Number # if you wish to
program the Call Forward – Immediate sequence).
Remember that when you program a * in the telco arm sequence, you enter *1 and when
you program the # in the telco arm sequence, you enter *2.
4. Press the
button when finished. Two beeps will be heard and the system will return to
the disarmed state.
+
3
+
1
+
161
+ +
2
+
Example
If you wish to automatically divert all unanswered incoming calls to another telephone number (e.g.:
9672 1777) when the system is armed in AWAY Mode, follow the example sequence below and
replace the telephone number mentioned in the manual with the telephone number that you wish to
divert all calls to. Remember to substitute the default Master Code (2580) with the Master Code that
has been programmed.
2580
+
3
+
+
1
+ +
161
+
96721777
+
2
+
How To Disable The Telco Arm Sequence
If at any time you wish to cancel the telco arming sequence, you may enter the following sequence.
+
3
+ +
1
+
+ +
4
+
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited