System Functions 85
How To Program The Telco Disarm Sequence
1. Enter your followed by 3and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Press button
2 followed by the button to change the telco disarm sequence. Three
beeps will be heard.
If a previous telco disarming sequence has already been programmed, the sequence will be
displayed one digit at a time via the remote codepad indicators.
If no telco disarming sequence has been programmed, a further two beeps will be heard after
entering this mode. These two beeps are normally heard after the last digit of the call forward
sequence has been displayed.
3. Enter the call forward disable sequence that you require (e.g.: #61# if you wish to disable the
Call Forward – No Answer sequence, or #21# if you wish to disable the Call Forward –
Immediate On sequence.
Remember that when you program the # in the telco disarm sequence, you enter *2.
4. Press the # button when finished.
Two beeps will be heard and the system will return to the disarmed state.
+
3
+
2
+
261 2
+
How To Disable The Telco Disarm Sequence
If at any time you wish to cancel the telco disarm sequence, you may enter the following sequence.
+
3
+ +
2
+
+ +
4
+
Electronics Design and Manufacturing Pty Limited ISSUE162.DOC
To Next Page
Loading...