EDM Solution Ultima 844 - Page 80

80 Solution Ultima 844/862/880 Installation Manual
How To Delete A Remote Radio User Code
1. Enter your followed by 1and the button.
Three beeps will be heard and the
STAY and AWAY indicators will begin to flash.
2. Enter the (9-16) that you wish to delete followed by the button.
Two beeps will be heard and the corresponding
ZONE indicator will illuminate. Refer to
"Table 38: Codepad Indicators Showing Relative Remote User Numbers" on page 80.
3. Press the button to delete the user code.
Two beeps will be heard and the
STAY and AWAY indicators will extinguish.
If you wish to delete additional remote radio user codes, repeat this procedure as many times as
required.
+
1
+
+ + +
When deleting remote radio user codes, this function will automatically terminate if a button is
not pressed within sixty seconds or by pressing the button will also terminate the
session at anytime. One long beep indicates the an incorrect user number has been selected.
User
No
Zone 1
Indicator
Zone 2
Indicator
Zone 3
Indicator
Zone 4
Indicator
Zone 5
Indicator
Zone 6
Indicator
Zone 7
Indicator
Zone 8
Indicator
MAINS
Indicator
9
 
10

11
 
12
 
13
 
14
 
15
 
16
 
Table 38: Codepad Indicators Showing Relative Remote User Numbers
ISSUE162.DOC Electronics Design and Manufacturing Pty Limited